How do I apply the paint?
Once you have followed the correct surface preparation procedures for your swimming pool, you will be ready to apply the finish coats of paint.
Remember that the surface preparation is of primary importance.
If these instructions are followed you should not encounter any paint problems.
Repainting with Rubber Base Paints:
Paralon 2:
MAKE SURE THE POOL SURFACE IS 100% DRY.
This is critical.
Water trapped under the paint film will eventually result in blistering as vapors try to escape.
Spot prime any bare spots with the rubber base paint.
Paralon 2 is self-priming.
Rubber base paints require two coats if best results are to be expected.
If the surface is bare, thin the first coat 25% with #1108 Thinner.
Using a 9' roller with a 7/16" nap wilt provide excellent results.
Ask for a roller cover with a solvent resistant core.
Apply the first coat of paint in a smooth even manner.
Allow this first coat to dry before applying the second coat of paint.
The second coat should be applied at full strength.
It is always best to start and finish painting in a corner if there will be periods when you are not working.
This wilt eliminate any tap marks that might occur.
Curing schedule before filling pool: Average minimum days depending on temperature.
Coverage: 250 sq. ft. average per gallon for Paralon 2.
Application of Epoxy Coatings
The Poxolon System
If applying Poxolon to a bare surface, be sure to use the appropriate primer, depending on the surface.
When repainting old epoxy, make certain that all glossy surfaces of the old paint are dulled down by light sanding.
Most important!
Prior to the application of any coating follow the three step cleaning process.
Use a 9" lambswool roller cover with a solvent resistant core.
While painting, use firm even strokes with plenty of paint in the roller to squeeze the paint into the porous surface.
This will insure good adhesion.
Apply the second coat of Poxolon when the surface is dry enough to walk on without marring the finish.
You will get more coverage out of the second coat and it will be quicker to apply.
Allow the second coat to cure as recommended on the curing schedule below before filling your pool with water.
For steps, shallow areas and wading pools, we recommend sprinkling white sand or marble dust on the paint before it dries to make the area slip-resistant.
The ZERON System:
Application of the Zeron system is best with a 9" lambswool roller cover with a 7/16" nap and a solvent resistant core.
See the section on epoxy coatings to determine the proper coating procedure for your present surface condition.
If you are recoating an epoxy finish, be sure to lightly sand any glossy spots in order to assure good adhesion.
Spot prime any bare spots with the recommended primer shown on page 3.
Allow this primer to cure for the proper time and you am ready to apply Zeron.
Zeron requires only one coat.
A liberal application of 10 mils will provide a very durable finish.
Be sure to paint the walls first and the floor last.
Allow the Zeron to cure for the recommended period as shown in the curing schedule below.
Curing Schedule Before Filling Pool
3 days @ 75° F. to 85° F. (25° C.)
4 days @ 70° F. to 75° F. (21° C.)
5 days @ 65° F. to 70° F. (18° C.)
6 days @ 60° F. to 65° F. (16° C.)